Selling Point

• Policy for Manufacturing
• Sloped Dual type Draw Bench
• Horizontal Dual type Draw Bench

CONTACT US

e-mail

1. 

   1. Use the column material (square steel pipes) for a machine which can be also used for buildings.
   2. Ensure the rigidity by all in one structure of a whole machine not depending on its concrete base.
   3. Utilize the original absorbing torque system together with a reducer as all in one structure in a machine.

2. 

   1. Symmetry design placing the drawing chains horizontally.
   2. Lift up a product from upper side by the clamp even though it is dual type.
   3. Easy cleaning and maintenance by the column material (square steel pipes) for a machine.

3. 

   1. Utilize the clamp for the sure loading of a material.
   2. Renovate a work flow without handling a material.
   3. Plug automatic insertion system by the carriage.

Dual Type
Horizontal Dual type (FUJIOKA-KOSAKUSHO. Original)
Cross Section	Machine Specification Summary
	The Horizontal Dual type as well as the Dual type has a drawing centre and chain centre on the same line and surely loads and lifts up from the upper side together with the work lamp. In addition, it renovates the work flow in the past, where it becomes all automatic for loading, inserting a core, drawing and lifting up. First, load a mother tube in the position of drawing by the work lamp. Then insert the material into the core of the mother tube by the carriage. In that time the die plate goes up and down and the die plate transfers to the position of inserting into the core. After inserting, the dice plate returns to the position of die drawing. After drawing, lift up the product by the work lamp. The Sloped Dual type Draw Bench is good for half automation including an operator. The Horizontal Dual type Draw Bench is good for all automation. In case of utilizing the all automation, you need a loading device additionally.